Hyundai Kona: ISG (Idle Stop & Go) System / Brake Switch Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Brake Switch Repair procedures

Inspection

Inspect a removed stop lamp switch along the below procedures.

(1)

Confirm a normal connection with terminal part

–	A confirmation can be made to see if the connector has been secured properly and if a connection mark is present.

Removal

1.	Turn ignition switch OFF and disconnect the negative (-) battery cable.

2.	Remove the crash pad lower panel. (Refer to Body (Interior and Exterior) - "Crash Pad")

3.	Disconnect the brake switch connector (A).

Installation

1.	Install in the reverse of removal.

Brake Switch Schematic diagrams

Schematic Diagram Schematic Circuit Diagram Terminal function Teminal Description 1 IGN1 ...

Door Switch Description and operation

Description Via the seat belt/Door switch, the ISG function can detect that the driver has fastened the seat belt/door. If the driver has not fastened the seat belt/door, the ISG ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Rear Seat Belt Retractor Components and components location
Component Location 1. Rear seat belt retractor ...

Hyundai Kona (OS) 2018-2026 Service Manual: Power Door Mirror Actuator Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door quadrant inner cover (A). 3. Disconnect the power door mirror connector from the harnes ...