Ford Fusion: Seats / Head Restraints

WARNING: Fully adjust the head restraint before you sit in or operate your vehicle. This will help minimize the risk of neck injury in the event of a crash. Do not adjust the head restraint when your vehicle is moving.

WARNING: The head restraint is a safety device. Whenever possible it should be installed and properly adjusted when the seat is occupied. Failure to adjust the head restraint properly could reduce its effectiveness during certain impacts.

Note: Adjust the seat backrest to an upright driving position before adjusting the head restraint. Adjust the head restraint so that the top of it is level with the top of your head and as far forward as possible. Make sure that you remain comfortable. If you are extremely tall, adjust the head restraint to its highest position.

Front Seat and Rear Seat Outboard Head Restraints

Ford Fusion. Head Restraints

Rear Center Head Restraint

Ford Fusion. Head Restraints

The head restraints consist of:

  1. An energy absorbing head restraint.
  2. Two steel stems.
  3. Guide sleeve adjust and unlock button.
  4. Guide sleeve unlock and remove button (If Equipped).

Adjusting the Head Restraint

Raising the Head Restraint

Pull the head restraint up.

Lowering the Head Restraint

  1. Press and hold button C.
  2. Push the head restraint down.

Removing the Head Restraint (If Equipped)

  1. Pull the head restraint up until it reaches its highest position.
  2. Press and hold buttons C and D.
  3. Pull the head restraint up.

Installing the Head Restraint

Align the steel stems into the guide sleeves and push the head restraint down until it locks.

Tilting Head Restraints (If Equipped)

Ford Fusion. Head Restraints

The front head restraints tilt for extra comfort.

  1. Adjust the seat backrest to an upright driving or riding position.
  2. Pivot the head restraint forward toward your head to the desired position.

After the head restraint reaches the forward-most tilt position, pivot it forward again to release it to the rearward, un-tilted position.

Sitting in the Correct Position
WARNING: Sitting improperly, out of position or with the seatback reclined too far can take weight off the seat cushion and affect the decision of the passenger sensing system, resulting in serio ...

Manual Seats (If Equipped)
WARNING: Do not adjust the driver seat or seatback when your vehicle is moving. WARNING: Rock the seat backward and forward after releasing the lever to make sure that it is fully engaged. WARNIN ...

Other information:

Hyundai Kona (OS) 2018-2021 Owners Manual: Checking the tire inflation pressure
1. After driving approximately 7~10 km (4~6 miles or about 10 min), stop at a safety location. 2. Connect the connection hose (9) of the compressor directly to the tire valve. 3. Plug the compressor power cord into the vehicle power outlet. 4. Adjust the tire inflation pressure to the recomended t ...

Hyundai Kona (OS) 2018-2021 Service Manual: Alternator Specifications
Specifications Item Specification Nominal output 13.5V 130A Speed in use 1,000 - 18,000 rpm Regulator Type IC Regulator built in type ECM Interface type reg ...

© 2018-2021 www.hkona.com