Hyundai Kona: Headlamp and front fog lamp aiming (for Europe) / Headlamp low beam (RHD side)

1. Turn the low beam on without driver aboard.

2. The cut-off line should be projected in the cut-off line shown in the picture.

3. When aiming the low beam, vertical aiming should be adjusted after adjusting the horizontal aiming.

4. If headlamp leveling device is equipped, adjust the head lamp leveling device switch with 0 positions.

Headlamp low beam (LHD side)
1. Turn the low beam on without driver aboard. 2. The cut-off line should be projected in the cut-off line shown in the picture. 3. When aiming the low beam, vertical aiming should be adjusted after ...

Front fog lamp
1. Turn the front fog lamp on without the driver aboard. 2. The cut-off line should be projected in the allowable range (shaded region). ...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Input shaft speed sensor 2 Components and components location
Components 1. Input shaft speed sensor 1 (Odd) 2. Input shaft speed sensor 2 (Even) ...

Hyundai Kona (OS) 2018-2026 Service Manual: Alternator Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the battery negative (-) terminal. 2. Disconnect the air compressor connector (A) and the alternator connector (B), and remove the cable (C) from alternator "B" terminal. ...

В© 2018-2026 www.hkona.com