Hyundai Kona: Maintenance / Light bulbs

Consult an authorized HYUNDAI dealer to replace most vehicle light bulbs. It is difficult to replace vehicle light bulbs because other parts of the vehicle must be removed before you can get to the bulb. This is especially true for removing the headlamp assembly to get to the bulb(s).

Removing/installing the headlamp assembly can result in damage to the vehicle.

WARNING

Prior to working on a light, firmly apply the parking brake, ensure that the ignition switch is in the LOCK/OFF position and turn off the lights to avoid sudden movement of the vehicle and burning your fingers or receiving an electric shock.

NOTICE

Be sure to replace the burned-out bulb with one of the same wattage rating. Otherwise, it may cause damage to the fuse or electrical wiring system.

Information

After heavy driving rain or washing, headlamp and tail lamp lenses could appear frosty. This condition is caused by the temperature difference between the lamp inside and outside. This is similar to the condensation on your windows inside your vehicle when raining and doesn’t indicate a problem with your vehicle. If the water leaks into the lamp bulb circuitry, we recommend that the system be checked by an authorized HYUNDAI dealer.

Information

The headlamp aiming should be adjusted after an accident or after the headlamp assembly is reinstalled at an authorized HYUNDAI dealer.

Information - Traffic Change (for Europe)

The low beam light distribution is asymmetric. If you go abroad to a country with opposite traffic direction, this asymmetric part will dazzle oncoming car driver. To prevent dazzle, ECE regulation demand several technical solutions (ex. automatic change system, adhesive sheet, down aiming). These headlamps are designed not to dazzle opposite drivers. So, you need not change your headlamps in a country with opposite traffic direction.

Engine compartment fuse panel (Battery terminal cover)
Inside the fuse/relay box cover, you can find the fuse/relay label describing fuse/relay names and ratings. Information Not all fuse panel descriptions in this manual may be applicable to your vehic ...

Headlamp, Low beam assist – Static, position lamp, turn signal lamp and daytime running light bulb replacement
Type A (1) Headlamp (High) (2) Headlamp (Low) (3) Daytime running light (if equipped) / Position lamp (4) Turn signal lamp (5) Front fog lamp (if equipped) WARNING Handle halogen bulbs with care. ...

Other information:

Hyundai Kona (OS) 2018-2024 Service Manual: Rear Seat Assembly Repair procedures
Replacement [Rear seat cushion assembly] 1. Remove the luggage covering board (A). 2. Remove the luggage floor center tray assembly (A). 3. Pull up the rear seat back assembly (A) by pulling ...

Hyundai Kona (OS) 2018-2024 Service Manual: ETC (Electronic Throttle Control) System Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Specification : Refer t ...

© 2018-2024 www.hkona.com