Hyundai Kona: Seat Electrical / Power Seat Motor Repair procedures

Inspection

Power Seat Motor

1.	Disconnect the connectors for each motor. [Slide Motor] [Rear Height Motor] [Front Height Motor] [Reclining Motor] [Lumbar Support Motor]

2.	With the battery connected directly to the motor terminals, check if the motors run smoothly.

3.	Reverse the connections and check that the motor turns in reverse.

4.	If there is an abnormality, replace the motors. [Driver / Assist]

[Reclining Motor Limit Switch]

•	The power seat motor(IMS specification) mounted in this vehicle uses the hole sensor to calculate the maximum operation distance, so it does not require limit switch.

•	But, NON- IMS specification driver seat and passenger seat have limit switches in the motor in the back of the chairs.

1.	Disconnect the limit switch and operate the limit switch.

2.	Check for continuity between the terminals.

3.	Make sure that the seat operation is normal in the reverse after the maximum operation.

4.	If there is an abnormality, replace the limit switch.

Remove

Front Seat

1.	Disconnect the battery terminals.

2.	Remove the front seat assembly. (Refer to Body - "Front Seat Assembly")

Component Location 1. Lumber support motor (Horizontal) 2. Rear height motor 3. Reclining motor 4. Slide motor 5. Front height motor 6. ...

Circuit Diagram ...

Hyundai Kona (OS) 2018-2026 Service Manual: ICM (Integrated Circuit Module) Relay Box Repair procedures
Inspection Out Side Mirror Folding Relay Check for continuity between the terminals. 1. There should be continuity between the No.9 and No.19 terminals when power and ground are connected to the No.10 and No.20 in the ICM-B. ...

Hyundai Kona (OS) 2018-2026 Service Manual: Multi-Function Camera Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the MFC unit cover (A). 3. Disconnect the MFC unit connector (A). 4. ...