Ford Fusion: Maintenance / Removing a Headlamp

Ford Fusion. Removing a Headlamp

Note: To remove push pins, use a flat-bladed screwdriver to pull up the center release pin.

  1. Make sure the headlamp control is in the off position and open the hood.
  2. Remove the six push pins securing the front fascia to the front trim cover.
  3. Remove the three bumper cover upper screws using a flat-bladed screwdriver.
  4. Remove the push pin at the inboard side of the headlamp you are servicing.

    Ford Fusion. Removing a Headlamp

  5. Remove the two screws securing the headlamp using a flat-bladed screwdriver.

    Ford Fusion. Removing a Headlamp

  6. Remove the lower three wheel housing fasteners by turning them counterclockwise.

    Ford Fusion. Removing a Headlamp

  7. Remove the two outmost front bumper cover lower fasteners, only on the side of the headlamp you are servicing, by turning them counterclockwise.

    Ford Fusion. Removing a Headlamp

  8. Separate the front bumper cover from the fender by gently pulling the front bumper cover to the outside of the vehicle 1.2 in (3 cm).

    Ford Fusion. Removing a Headlamp

  9. From the front of the vehicle, gently pull the front bumper cover forward 4 in (10 cm) by grasping it next to the headlamp to be serviced and in the lower front of the wheel opening.

    Ford Fusion. Removing a Headlamp

  10. Gently pull the headlamp assembly outward to disengage it from the lower fixing point.
  11. Carefully lift the headlamp and remove it from the vehicle.
  12. Disconnect the electrical connector from the headlamp assembly by pushing the release tab on the connector.
Adjusting the Headlamps
Vertical Aim Adjustment The headlamps on your vehicle are properly aimed at the assembly plant. If your vehicle has been in an accident, the alignment of your headlamps should be checked by your a ...

Changing a Bulb
WARNING: Switch the lamps and the ignition off. Failure to follow this warning could result in serious personal injury. WARNING: Bulbs can become hot. Let the bulb cool down before removing it. F ...

Other information:

Hyundai Kona (OS) 2018-2021 Owners Manual: Warning message and warning light
Forward Collision Avoidance Assist (FCA) system disabled. Radar blocked When the sensor cover is blocked with dirt, snow, or debris, the FCA system operation may stop temporarily. If this occurs, a warning message will appear on the LCD display. Remove any dirt, snow, or debris and clean the radar ...

Ford Fusion 2013–2020 Owners Manual: Car Finder. Sounding the Panic Alarm
Car Finder Press the button twice within three seconds. The horn sounds and the direction indicators flash. We recommend you use this method to locate your vehicle, rather than using the panic alarm. Sounding the Panic Alarm Note: The panic alarm only operates when the ignition is off. Press ...

© 2018-2021 www.hkona.com