Hyundai Kona: Air Conditioning System / Compressor oil Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Compressor oil Repair procedures

Oil Specification

1.	The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed.

2.	Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compressor.

Handling of Oil

1.	The oil should be free from moisture, dust, metal powder, etc.

2.	Do not mix with other oil.

3.	The water content in the oil increases when exposed to air. After use, seal oil from air immediately. (HFC-134a Compressor Oil absorbs moisture very easily.)

4.	The compressor oil must be stored in steel containers, not in plastic containers.

Compressor Oil Check

The oil used to lubricate the compressor circulates with the refrigerant.

Whenever replacing any component of the system or a large amount of gas leakage occurs, add oil to maintain the original amount of oil.

Oil total volume in system

PAG 30 120 ± 10cc (4.23 ± 0.35oz.)

Oil Return Operation

There is close affinity between the oil and refrigerant.

During normal operation, part of the oil recirculates with the refrigerant in the system. When checking the amount of oil in the system, or replacing any component of the system, the compressor must run in advance for oil return operation. The procedure is as follows:

1.	Open all the doors and engine hood.

2.	Start the engine and air conditioning switch to "ON" and set the blower motor control knob at its highest position.

3.	Run the compressor for more than 20 minutes between 800 and 1,000 rpm in order to operate the system.

4.	Stop the engine.

Components and components location

Component Location Index Engine Room 1. Expansion valve 2. Service port (Low pressure) 3. Service port (High pressure) 4. A/C Pressure transdu ...

Refrigerant Line Components and components location

Components Location 1. Suction & Liquid tube assembly ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: If the engine overheats
If your temperature gauge indicates overheating, you experience a loss of power, or hear loud pinging or knocking, the engine may be overheating. If this happens, you should: 1. Pull off the road and stop as soon as it is safe to do so. 2. Place the shift lever in P (Park, for dual clutch transmis ...

Hyundai Kona (OS) 2018-2026 Service Manual: Back View Camera System Description and operation
Description Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mir ...