Hyundai Kona: Transfer Assembly / Oil Seal Repair procedures

Replacement
1.
Remove the trasfer assembly.
(Refer to 4WD System - "Trasfer Assembly")
2.
Remove the oil seal (A).

3.
Remove the oil seal (A).
Install the new oil seal with SST (No. : 09473-D3600, 09231-H1100).

Installation
1.
To install, reverse the removal procedure.
Front Wheel Transfer Assembly Repair procedures
Removal 1. Remove the following items. (Refer to Suspension System - "Sub Frame") 2. Remove the propeller shaft (A). ...

4WD Control System
...

Other information:

Hyundai Kona (OS) 2018-2024 Service Manual: Rear Hub - Carrier Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque : 107.9 - 127.5 N. ...

Hyundai Kona (OS) 2018-2024 Owners Manual: Key ignition switch
Whenever the front door is opened, the ignition switch will illuminate, provided the ignition switch is not in the ON position. The light will go off immediately when the ignition switch is turned on or go off after about 30 seconds when the door is closed. (if equipped) WARNING • NEVER turn t ...

© 2018-2024 www.hkona.com