Hyundai Kona: Starting System / Starter Relay Repair procedures

Hyundai Kona (OS) 2018-2026 Service Manual / Engine Electrical System / Starting System / Starter Relay Repair procedures

Inspection
1.
Turn ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Remove the fuse box cover.
3.
Remove the starter relay (A).
4.
Check for continuity between the terminals (30 and 87) using an ohmmeter.
Terminal
Resistance
Measure
30 - 87
 1MΩ or higher
 If there is continuity between the terminals, replace the relay.

5.
Apply 12V to the terminal 85 and ground to the terminal 86 and then check for continuity between the terminals (30 and 87).
Terminal
Resistance
Measure
30 - 87
 1Ω or less
 If there is no continuity between the terminals, replace the relay.

6.
Install the starter relay.
7.
Install the fuse box coveCalibration beam
Starter Repair procedures
Removal 1. Disconnect the battery negative terminal. 2. Remove the under cover. (Refer to Engine Mechanical System - "Engine R ...

Cruise Control System
...

Other information:

Hyundai Kona (OS) 2018-2026 Service Manual: Alternator Description and operation
Description The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal.In addition, the charging voltage of this alternator is regulated by the battery voltage detection system. The a ...

Hyundai Kona (OS) 2018-2026 Service Manual: Front Wheel Speed Sensor Components and components location
Components 1. Front wheel speed sensor 2. Front wheel speed sensor connector ...

© 2018-2026 www.hkona.com