Hyundai Kona: Tire Pressure Monitoring System / TPMS Receiver Description and operation

Hyundai Kona (OS) 2018-2026 Service Manual / Suspension System (NON-ECS) / Tire Pressure Monitoring System / TPMS Receiver Description and operation

Description

TPMS Receiver : BCM(body control module) integrated management

Mode

(1)

Virgin State

•	The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state.

•	In this state, there is no Auto-Location, no sensor wake-up, no sensor monitoring and no DTC monitoring..

•	The state indicates that platform specific parameters must be written to the receiver and that sensors are un-learned.

(2)

Normal State

•	In order for tire inflation state and DTC monitoring to occur, the receiver must be in this state.

•	In this state, automatic sensor location / learning is enabled.

Overview

•	Learn TPMS sensor for under inflation monitoring automatically.

•	Uses sensor information, distance travelled, background noise levels, Auto-learn status, short / open circuit output status, vehicle battery level, internal receiver states to determine if there is a system or a vehicle fault.

Operation

General Function

•	Auto-learn takes place only once per Ignition cycle.

•	On successful completion, 4 road wheel sensor ID's are latched into memory for monitoring.

•	Until Auto-learn completes, previously learned sensors are monitored for under inflation / leak warnings.

General Conditions to Learn New Sensors:

•	Receiver must determine that it is confident that sensor is not temporary: a. Uses vehicle speed. b. Uses confidence reduction of previously learned sensors.

•	Typical time at driving continuously over 15.5 mph(25 kph) to learn a new sensor is up to 20 minutes.

General Conditions to Un-Learn a sensor that is removed :

•	It takes less than 20 minutes at 15.5 mph(20-30 kph).

•	Confidence reduction is dependent on time which vehicle is driven at speed greater than or equal to 12.4 mph(20-30 kph).

TPMS Sensor Repair procedures

Replacement 1. Remove the wheel and tire. 2. Remove the valve core and deflate the tire. 3. Install the wheel ...

TPMS Receiver Repair procedures

Replacement [TPMS Receiver (Body Control Moduel (BCM))] 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. ...

Other information:

Hyundai Kona (OS) 2018-2026 Owners Manual: Resetting the system
The last break time is set to 00:00 and the driver's attention level is set to 5 (very attentive) when the driver resets the Driver Attention Warning (DAW) system. The Driver Attention Warning (DAW) system resets the last break time to 00:00 and the driver's attention level to 5 in the foll ...

Hyundai Kona (OS) 2018-2026 Service Manual: Power Mosfet Repair procedures
Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage ...